BCM5482 LINUX DRIVER

IME, when a link auto-negotiated to 10base half-duplex, there a serious cable issue, or the other end plain doesn’t support anything faster. For your problem, you have to find out how it is configured at the remote end. Now with VMware vSphere 4. If it is auto-negotiation, then you should use auto-negotiation on your server too. Software Development Environment Broadcom has created a.

Uploader: Voodooshura
Date Added: 14 August 2004
File Size: 28.15 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 3775
Price: Free* [*Free Regsitration Required]

Can you put another device like a switch between you and the Server that you can change the settings on physically? Previous 1 2 Evaluation report prepared under contract with Broadcom Corporation Introduction Enterprises are movingby Broadcom allow servers to fully leverage the available 10GbE bandwidth, while reducing processor.

Broadcom Corporation reserves the right to make changes to theinformation.

All rights reserved Broadcom Europe Ltd8. I also cannot dictate how the host’s switch is configured. Neither can I verify how they actually have it configured. Home Questions Tags Users Unanswered. For gigabit it is mandatory to have autoneg.

Linux source code: drivers/net/phy/broadcom.c (v) – Bootlin

Is there anything I can do remotely to identify the source of the problem, or at least eliminate possibilities? Email Required, but never shown.

  INTEL 82803 FIRMWARE HUB CAP DRIVER DOWNLOAD

Thanks, but this is ground covered by previous answers, comments, ljnux my question itself specifically the “Update” portion. Yes Advertised link modes: IME, when a link auto-negotiated to 10base half-duplex, there a serious cable issue, or the other end plain doesn’t support anything faster.

By clicking “Post Your Answer”, you acknowledge that you have read our updated terms of serviceprivacy policy and cookie policyand that your continued use of the website is subject to these policies. Post Your Answer Discard By clicking “Post Your Answer”, you acknowledge that you have read our updated terms bcm4582 serviceprivacy policy and cookie policyand that your continued use of lunux website is subject to these policies.

Again, the server is not within my llinux control, and swapping in hardware, adding in ncm5482, cables, etc are not something I can do from here. By implementing this solution, which has been developed jointly by VMware and Broadcomdata center architects and administrators can increase the number of virtualVMware vSphere 4. Broadcom ‘s WWRN and. There was a time when hardware didn’t negotiate properly, but that is no longer the case.

Please keep in mind that is possible to keep the negotiation on and allow only negotiation for a certain speed and duplex. Documentation is provided as is.

  CANON C2880I PRINTER DRIVER DOWNLOAD

CONFIG_BROADCOM_PHY: Broadcom PHYs

That’s not really an option. If it is set at a specific speed and duplex you should match the remote end. Also the advertising of capabilities can be configurable.

All rights reservedBroadcom Europe Ltd. If it is auto-negotiation, then you should use auto-negotiation on your server too. Software Development Environment Broadcom has created a. All rights reserved Broadcom Europe Ltd. If you don’t bcm4582 access to the switch on the other end of the Ethernet cable or that switch does not support such customization, then disabling auto-negotiation is not an option.

PHYLIB: Add BCM5482 PHY support [Linux 2.6.25]

To avoid having to constantly reboot the server, and to find out if the ethtool command was hanging, I switched to using this script:. Sign up using Email and Password. Server Fault works best with JavaScript enabled. You should also try with a different network card.

Broadcom provides line card design expertise as an integral part of the design support activity.